The Light my Bricks 2.0 Flare Light 26L in Red uses 384 LEDs across a length of 210 mm to create an intensely bright and even red line of light, making it ideal for bold accents and striking lighting effects in LEGO® models.
The Flare Light 26L was developed by Light my Bricks as a powerful LED light bar that integrates cleanly into LEGO® models. A total of 384 LEDs are distributed across the 210 mm light bar, producing a vibrant and consistent red glow along its entire length. Rather than creating individual points of light, it provides a continuous and uniform lighting effect.
The special design of the Flare Light 26L was developed as a direct replacement for a corresponding LEGO® hose element. This allows the light bar to fit seamlessly into compatible constructions and enables lighting solutions that would be difficult to achieve using individual LEDs.
The intense red light is particularly suitable for tail lights, warning and signal lights, science-fiction scenes, vehicles, machinery, technical models, energy effects and other areas where bold and even linear illumination is desired. With its 210 mm length, the Flare Light 26L is particularly well suited to large areas and long structures that need to be highlighted with a continuous red line of light.
Developed from over 10 years of experience
Light my Bricks has been developing lighting solutions for LEGO® sets for over 10 years. The experience gained during this time has been incorporated directly into the development of the new LMB 2.0 system. The components were developed by Light my Bricks to make them even smaller, thinner, more robust and easier to integrate into LEGO® models. The innovative design of the Light my Bricks 2.0 system has been recognised with a Good Design Award.
Pack contents:
- 1 x Light my Bricks 2.0 Flare Light 26L, Red
Technical specifications:
- Light colour: Red
- LEDs: 384
- Length: 26L / 210 mm
- Quantity included: 1 piece
- System: Light my Bricks 2.0
- Power supply: 5 V / 2.4 A
Power supply information: This component is designed for a 5 V / 2.4 A power supply. Only use a Light my Bricks power adapter or power bank that meets these specifications. The use of other power sources, particularly higher-voltage adapters, is at your own risk.
Easy Plug-and-Play system
Light my Bricks 2.0 components are designed to connect easily to one another. Unlike many conventional lighting components, there is no need to pay attention to positive and negative polarity when connecting the cables. Simply plug in and connect – the system takes care of the rest. No electronics knowledge or complicated settings are required.
With DIY components from Light my Bricks, individual areas, details or complete LEGO® models can be illuminated according to your own ideas. Flare Lights create particularly even linear lighting effects and are ideal for models where a powerful light bar needs to be cleanly integrated into the construction.